In almost every case, yes. A strap-on cup holder like the NIXY Floatsup attaches to your board's existing bungee rigging or D-rings with an adjustable cord, so it works on virtually any paddle board or kayak without drilling, gluing, or a permanent mount. The one exception is a bare board with no D-rings and no deck bungee, which leaves nothing to anchor to. If your board has a cargo area up front, you already have everything you need.
Most inflatable boards, including the whole NIXY G5 lineup, ship with a bungee cargo system and multiple D-rings on the deck. A strap-on holder loops onto that rigging and cinches down, so it stays put while you paddle and lifts off when you are done. Nothing about it is board-specific.
That is the beauty of a strap mount over a screw-in or glued fitting. You can move it between boards, take it off for storage, and adjust where it sits depending on whether you paddle standing or sit down to fish. It travels as easily as the rest of your kit.
Where it comes up short is a board with a completely flat, ring-free deck. Those are rare, but if that is what you have, a strap holder has nothing to grab. In that situation you would need a board with deck rigging, or an adhesive D-ring patch to create an anchor point first.
The NIXY Floatsup Cup Drink Holder ($19.95) straps onto your deck rigging in seconds and holds a drink upright while you paddle, so a hot day on the water comes with a cold drink within reach.
Frequently asked questions
How does a paddle board cup holder attach?
A strap-on holder like the Floatsup uses an adjustable cord that loops around your board's bungee rigging or D-rings and cinches tight. There is no drilling or glue, and you can move it between a paddle board and a kayak or take it off when you are done.
Will a cup holder fit my kayak too?
Yes. The same strap system that grips paddle board rigging works on a kayak's deck bungees or mounting points, so one holder covers both. It lifts off just as easily for storage or transport.
What if my paddle board has no D-rings?
A strap-on holder needs something to anchor to, so a completely bare deck will not work. Most boards have deck bungees or D-rings already. If yours does not, an adhesive D-ring patch can create an anchor point for the strap.
0 comments